|Classification:||Hot Melt Glue Granule||Main Raw Material:||Animal Bone Glue With Various Of Additives|
|Other Names:||Cyanoacrylate Adhesive||Color:||Light Yellow|
|Shelf Life:||12 Months At Least||Name:||Good Price Animal Hotmelt Jelly Glue For Hardcover Book|
|Product Name:||Hot Melt Adhesive,Jelly Animal Glue||Material:||Ethylene Vinyl Acetate(EVA) And Resin|
5.5PH Bone Glue Powder,
cyanoacrylate adhesive Bone Glue Powder,
EVA Hot Melt Glue Granules
Hot Melt Adhesives Bone Glue Powder
|Color||Status||Solid Content||Viscosity||Speed||PH||Packing||Storage Temperature||Storage Life|
|Light Yellow||Granule and powder||99±1%||5 mpa.s||20-45 Case/min||5.5-7||25kg/carton||5-28℃||6 Months|
When using bone glue, soak bone glue with the same volume or a little more water( had better use hot water) for 10 hours or so, make the glue soft, then heat to 75℃ or so, make it into glue solution can be used, The ratio of glue to water should be determined according to the required viscosity, such as water more viscosity is low and thin: add water less viscosity is high and thick. When hot glue temperature should not be too high, temperature is more than 100℃ will be due to molecular degradation and viscosity decline, gum again deterioration. Bone glue is used in the use of a small amount of precipitation, so it is necessary to use the side of the well stirring, in order to regulate viscosity and fluidity, when hot glue must use the bath method, never store glue containers directly heating.
Bone glue should be kept in a certain temperature condition can be used, therefore, when the use of water, water and colloidal temperature should be basically the same, can not add cold water. Because the bone glue should maintain a certain temperature (75℃±10℃), the temperature of the glue will suddenly drop after adding cold water, which will affect the bonding effect. When using bone glue, the adhesive speed should be fast and uniform, do not dip in glue too much to cause uneven adhesive layer, penetration adhesive leakage problems.
Put the glue into the glue tank ,with 5%-10% hot water also, setup the water temperature of glue tank of machine between 70 centidegree to 80 centidegree. After waiting the glue complete melting, the stirred rubber is in the same state and fluidity as water, while guaranteeing that its viscosity is suitable for the viscosity required for production. Then it can be produced.
Applicable to the machine
We attended at least three oversea exhibitions every year to show our products to clients, warmly welcome to visit our booth in the exhibitions
Packing and Shipping
Packing by canton boxes, then put onto the pallets for shipping.